Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FUSION AWD V6-3.0L FLEX FUELREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCABIN TEMPERATURE SENSOR / SWITCHSERVICE AND REPAIRAMBIENT AIR TEMPERATURE SENSOR
2012 Ford Fusion AWD V6-3.0L Flex Fuel
Ambient Air Temperature Sensor
2012 Ford Fusion AWD V6-3.0L Flex FuelSECTION Ambient Air Temperature Sensor
Ambient Air Temperature Sensor
Removal and Installation
1. Remove the 4 lower radiator air deflector front screws.
2. Remove the 4 lower radiator air deflector pin-type retainers.
3. Remove the 2 lower radiator air deflector rear screws.
4. Remove the lower radiator air deflector.
5. Detach and disconnect the ambient air temperature sensor electrical connector.
6. Remove the ambient air temperature sensor.
7. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.