Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FOCUS L4-2.0LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDSHIELDWINDSHIELD MOULDING / TRIMSERVICE AND REPAIR
2012 Ford Focus L4-2.0L
Windshield Moulding / Trim: Service and Repair
2012 Ford Focus L4-2.0LSECTION Service and Repair
Applique - Windshield
Door Glass Top Run - Front
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Remove the windshield applique.
1. Push down on the corner of the cowl panel grille at the base of the windshield applique.
2. NOTICE: Make sure the windshield applique clips are fully dis-engaged prior to removing the applique or damage to the component and bracket can occur.
Slide the windshield applique downward approximately an inch past the fender edge to dis-engage the windshield applique clips and remove the windshield applique.
Installation
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.