Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Input Shaft - Inner
2012 Ford Focus L4-2.0LSECTION Input Shaft - Inner
Input Shaft - Inner
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Special Tool(s)
Exploded View
Disassembly
1. Remove the inner input shaft needle bearing.
2. Remove the inner input shaft needle bearing.
3. Remove the inner input shaft roller bearing.
4. Using 205-D064 (D84L-1123-A) and a press, remove the inner input shaft radial bearing.
Assembly
1. Inspect the inner input shaft for wear or damage, replace as needed.
2. Using 205-D064 (D84L-1123-A) and a press, install the inner input shaft radial bearing.
3. Install the inner input shaft roller bearing.
4. Install the inner input shaft needle bearing.
5. Install the inner input shaft needle bearing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.