Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FOCUS L4-2.0LREPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONAUXILIARY POWER OUTLETSERVICE AND REPAIR
2012 Ford Focus L4-2.0L
Auxiliary Power Outlet: Service and Repair
2012 Ford Focus L4-2.0LSECTION Service and Repair
Power Point
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Special Tool(s)
Removal
1. Open the power point cover.
2. Install 501-039 in one of the power point socket slots.
3. Position 501-039 so that it engages in the adjacent slot.
4. Using 501-039 , pull the power point socket out of the retainer.
5. Disconnect the electrical connector.
Installation
1. Connect the electrical connector.
2. Slide the power point socket into the retainer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.