Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FOCUS L4-2.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONFUEL PRESSURE SENSOR/SWITCHSERVICE AND REPAIRFUEL PRESSURE SENSOR
2012 Ford Focus L4-2.0L
Fuel Pressure Sensor
2012 Ford Focus L4-2.0LSECTION Fuel Pressure Sensor
Fuel Pressure Sensor
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Exploded View
Removal
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to follow these instructions may result in serious personal injury.
1. Release the fuel system pressure. REFER to Fuel System Pressure Release .
2. Disconnect the battery ground cable. REFER to Battery Disconnect .
3. Disconnect the fuel pressure sensor electrical connector.
4. NOTICE: During repair procedure, cleanliness is extremely important. Any foreign material, including any material created while cleaning or removing components that enters the fuel supply passages may cause engine failure.
NOTE: Use compressed air to remove any foreign material from around the fuel pressure sensor area before removal.
Remove and discard the fuel pressure sensor.
- To install, tighten to 14 Nm (124 lb-in)
Installation
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.