Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Speed Sensor - Rear
2012 Ford Focus L4-2.0LSECTION Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Exploded View
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. REFER to Lifting Points .
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 4.8 Nm (42 lb-in).
Installation
1. Inspect and install a new O-ring seal as necessary.
2. NOTE: Make sure that the sensor housing is clean and free of foreign material.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.