Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FLEX AWD V6-3.5LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER ARMSERVICE AND REPAIRWIPER PIVOT ARM - FRONT
2012 Ford Flex AWD V6-3.5L
Wiper Pivot Arm - Front
2012 Ford Flex AWD V6-3.5LSECTION Wiper Pivot Arm - Front
Wiper Pivot Arm - Front
Removal and Installation
1. Remove the wiper pivot arm nut cover.
2. NOTE: A suitable 2 jaw puller may be necessary to remove the wiper pivot arm.
Remove the nut and the wiper pivot arm.
- To install, tighten to 25 Nm (18 lb-ft).
3. To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to Wiper Blade and Pivot Arm Adjustment- Windshield .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.