Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FLEX AWD V6-3.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRBATTERY TRAY
2012 Ford Flex AWD V6-3.5L
Battery Tray
2012 Ford Flex AWD V6-3.5LSECTION Battery Tray
Battery Tray
Removal and Installation
1. Remove the battery. For additional information, refer to Battery .
2. Remove the Air Cleaner (ACL) assembly.
3. Disconnect the wiring harness fastener from the battery tray.
4. Remove the 3 bolts and 1 nut from the battery tray.
- To install, tighten to 15 Nm (133 lb-in).
5. Disconnect the Battery Junction Box (BJB) fastener and remove the battery tray.
6. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.