Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FLEX AWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMCONSOLESERVICE AND REPAIRCONSOLE - OVERHEAD
2012 Ford Flex AWD V6-3.5L
Console - Overhead
2012 Ford Flex AWD V6-3.5LSECTION Console - Overhead
Console - Overhead
NOTE: Overhead console with roof opening panel is shown, overhead console without roof opening panel is similar.
Removal and Installation
1. Remove the overhead console in the following sequence.
1. Pull the rear of the overhead console downward to release the retaining clips.
2. Disconnect the electrical connectors.
2. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.