Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FLEX AWD V6-3.5L TURBOREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER SWITCHSERVICE AND REPAIR
2012 Ford Flex AWD V6-3.5L Turbo
Windshield Washer Switch: Service and Repair
2012 Ford Flex AWD V6-3.5L TurboSECTION Service and Repair
Steering Column Multifunction Switch
NOTE: Steering wheel without paddle shifters shown, steering wheel with paddle shifters similar.
Removal and Installation
1. Remove the steering column shrouds.
2. Remove the 4 nuts and lower the steering column.
- To install, tighten to 18 Nm (159 lb-in).
3. Disconnect the multifunction switch electrical connector.
4. Remove the 2 screws and the multifunction switch.
- To install, tighten to 1 Nm (9 lb-in).
5. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.