Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FLEX AWD V6-3.5L TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTEMISSION CONTROL SYSTEMSAPPLICATION AND IDVEHICLE CERTIFICATION LABEL
2012 Ford Flex AWD V6-3.5L Turbo
Vehicle Certification Label
2012 Ford Flex AWD V6-3.5L TurboSECTION Vehicle Certification Label
VEHICLE CERTIFICATION LABEL
Base Engine Calibration Information
Base engine calibration information, sometimes referred to as the powertrain calibration, is located in the lower right corner of the vehicle certification label. Engine calibration information is limited to a maximum of 5 characters per line (2 lines maximum). Calibration information more than 5 characters long wraps to the second line of this field. Only the base calibration appears on this label. The revision level is no longer printed on the label. However, it can be found in the On-Line Automotive Service Information System (OASIS). For additional information on the vehicle certification label or engine calibration, refer to the Vehicle Identification Codes.
Vehicle Certification Label
Location The vehicle certification label is typically located on the LH door or door post pillar.
Engine Calibration Code
Base Engine Calibration Information
Base engine calibration information, sometimes referred to as the powertrain calibration, is located in the lower right corner of the vehicle certification label. Engine calibration information is limited to a maximum of 5 characters per line (2 lines maximum). Calibration information more than 5 characters long wraps to the second line of this field. Only the base calibration appears on this label. The revision level is no longer printed on the label. However, it can be found in the On-Line Automotive Service Information System (OASIS). For additional information on the vehicle certification label or engine calibration, refer to the Vehicle Identification Codes.
Vehicle Certification Label
Location The vehicle certification label is typically located on the LH door or door post pillar.
Engine Calibration Code
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.