Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FLEX AWD V6-3.5L TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR TEMPERATURE SENSOR ( AMBIENT / INTAKE )SERVICE AND REPAIRINTAKE AIR TEMPERATURE (IAT) SENSOR
2012 Ford Flex AWD V6-3.5L Turbo
Intake Air Temperature (IAT) Sensor
2012 Ford Flex AWD V6-3.5L TurboSECTION Intake Air Temperature (IAT) Sensor
Intake Air Temperature (IAT) Sensor
Removal and Installation
1. Disconnect the Intake Air Temperature (IAT) sensor electrical connector.
2. Remove the IAT (Intake Air Temperature) sensor.
- Lift the tab and turn the IAT (Intake Air Temperature) sensor counterclockwise to remove.
3. To install, reverse the removal procedure.
- Make sure the IAT (Intake Air Temperature) sensor tab is fully seated during installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.