Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor





Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove and discard the heat tape from the Output Shaft Speed (OSS) sensor and electrical connector.





3. Disconnect the OSS (Output Shaft Speed) sensor electrical connector.





4. Remove the OSS (Output Shaft Speed) sensor bolt and OSS (Output Shaft Speed) sensor.





Installation

1. Inspect the transaxle case bore. Clean and/or repair as needed.

2. Inspect the OSS (Output Shaft Speed) sensor for debris or damage. Clean or replace the OSS (Output Shaft Speed) as needed.

3. NOTE: If installing the old OSS (Output Shaft Speed) sensor, install a new O-ring.
Apply a small amount of transmission fluid to the O-ring and install the OSS (Output Shaft Speed) sensor and the OSS (Output Shaft Speed) sensor bolt.

- Tighten to 10 Nm (89 lb-in).






4. Connect the OSS (Output Shaft Speed) sensor electrical connector.





5. Thoroughly clean the OSS (Output Shaft Speed) sensor, electrical connector and wire.

6. Install new heat tape on the OSS (Output Shaft Speed) sensor as shown in the preceding steps.

7. Remove the heat tape backing only from this location first.





8. Wrap the heat tape around the OSS (Output Shaft Speed) sensor wiring harness.





9. Remove the heat tape backing from the rest of the heat tape and wrap it around the OSS (Output Shaft Speed) sensor and sticking the ends together.





10. Fold the remaining portion of the heat tape and crimp around the edge starting from the sensor portion moving around.