Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Fluid Level Check
2012 Ford Fiesta L4-1.6LSECTION Transmission Fluid Level Check
Transmission Fluid Level Check
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: Prior to removal, clean the area around the fill plug.
Remove the fill plug.
3. NOTE: Do not overfill the transaxle. This causes transmission fluid to be forced out of the case.
Using a suitable oil suction gun, fill the transaxle to the correct level with the specified fluid. Add transmission fluid until the oil runs out of the fill port in a continuous stream. The transaxle is full when the oil flow from the fill port has slowed to a broken stream or dripping.
4. NOTE: Use a ball head hex socket to tighten the transaxle fill plug.
Install the fill plug.
- Tighten to 43 Nm (32 lb-ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.