Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transaxle Case
2012 Ford Fiesta L4-1.6LSECTION Transaxle Case
Transaxle Case
Disassembly
1. Remove and discard the halfshaft seal.
2. Using the special tools, remove the differential case bearing cup.
Assembly
1. NOTE: If a new differential gear bearing, transmission case, differential or clutch housing are installed, measure the differential shim for the correct size. For additional information, refer to Differential Shim Selection Differential Shim Selection.
Using the special tools, install the differential gear bearing cup.
2. Install the new halfshaft seal on the special tools.
3. Using the special tools, install the new halfshaft seal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.