Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FIESTA L4-1.6LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL SWITCHSERVICE AND REPAIR
2012 Ford Fiesta L4-1.6L
Turn Signal Switch: Service and Repair
2012 Ford Fiesta L4-1.6LSECTION Service and Repair
Steering Column Multifunction Switch
Removal and Installation
1. Pulling upward, detach the upper steering column shroud from the lower steering column shroud.
- Slide the upper steering column shroud out of the Instrument Cluster (IC) trim panel and remove the shroud.
2. Remove the 3 screws and the lower steering column shroud.
3. Remove the multifunction switch in the sequence shown.
1. Disconnect the electrical connector.
2. Push inward to release the locking clip.
3. Slide the multifunction switch upward on the carrier and remove the multifunction switch.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.