Turn Signals: Service and Repair

2012 Ford Fiesta L4-1.6LSECTION Service and Repair



Rear Lamp Assembly

4-Door Sedan










5-Door Hatchback









Removal and Installation

4-Door sedan rear outer lamp assembly

1. Remove the pin-type retainer and position the luggage compartment trim panel aside.

2. Remove the rear outer lamp assembly.
1. Remove the rear outer lamp assembly retaining nut.

2. Disconnect and remove the rear outer lamp assembly.


4-Door sedan rear inner lamp assembly

3. Remove the 10 pin-type retainers and the decklid trim panel.





4. Remove the rear inner lamp assembly.
1. Loosen the rear inner lamp assembly retaining nut.

2. Disconnect and remove the rear inner lamp assembly.


5-Door hatchback

5. Remove the 2 rear lamp assembly screws.

6. Remove the rear lamp assembly.
1. Pull the rear lamp assembly out.

2. Remove the 3 rear lamp assembly bulbs and remove the lamp assembly.


All vehicles

7. To install, reverse removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.