Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012FIESTA L4-1.6LREPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LIGHT SWITCHSERVICE AND REPAIR
2012 Ford Fiesta L4-1.6L
Brake Light Switch: Service and Repair
2012 Ford Fiesta L4-1.6LSECTION Service and Repair
Stoplamp Switch
Removal and Installation
NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch and cruise control deactivation switch. Install these switches with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing these switches with the brake pedal in any other position results in incorrect adjustment and damages the switches.
1. NOTE: The stoplamp switch is located above the cruise control deactivation switch (if equipped).
Rotate the stoplamp switch clockwise approximately one-eighth turn to remove the stoplamp switch.
2. To install, reverse the removal procedure.
- Perform the brake pedal switch adjustment. For additional information, refer to Vehicle Dynamic Systems Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.