Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Speed Sensor - Front
2012 Ford Fiesta L4-1.6LSECTION Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
NOTE: LH shown, RH similar.
Removal and Installation
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires Removal and Replacement.
2. Position the rear portion of the splash shield aside.
1. Remove the 3 pushpin retainers.
2. Position the splash shield aside.
3. Disconnect the wheel speed sensor electrical connector.
4. Detach the wheel speed sensor from the body and wheel knuckle.
5. Remove the wheel speed sensor bolt.
- To install, tighten to 9 Nm (80 lb-in).
6. Remove the wheel speed sensor.
7. NOTICE: The white stripe on the wheel speed sensor harness is used for orientation purposes. Correct routing of the wheel speed sensor and harness is essential to prevent contact damage to the harness.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.