Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012F 150 4WD V6-3.7LREPAIR AND DIAGNOSISSPECIFICATIONSCAPACITY SPECIFICATIONSDIFFERENTIAL ASSEMBLYSYSTEM SPECIFICATIONSCAPACITIES (4WD)
2012 Ford F 150 4WD V6-3.7L
Capacities (4WD)
2012 Ford F 150 4WD V6-3.7LSECTION Capacities (4WD)
Front Axle Fluid 3.5 pints (1.8L)
Rear Axle Fluid 5.5 pints (2.6L)*
* Service refill capacity is determined by filling the axle to 1/4-9/16 inch (6-14 mm) below the bottom of the filler hole with the vehicle on a level surface.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.