Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
In-Dash Computer
2012 Ford F 150 2WD V8-6.2LSECTION In-Dash Computer
In-Dash Computer
NOTE: The AM/FM Audio Front Control Module (ACM) is shown in the illustration. The in-dash computer is similar, and mounts in the same physical location.
Removal and Installation
1. Remove the instrument panel finish panel - center lower.
2. Remove the 4 screws and the in-dash computer.
- Disconnect the electrical connectors.
3. NOTICE: Make sure the modem-antenna cable is routed to allow enough clearance for the in-dash computer. Failure to follow this instruction may result in damage to the modem-antenna cable.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.