Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012F 150 2WD V8-6.2LREPAIR AND DIAGNOSISBODY AND FRAMEAUXILIARY STEP / RUNNING BOARDSERVICE AND REPAIRPOWER RUNNING BOARD (PRB) STEP
2012 Ford F 150 2WD V8-6.2L
Power Running Board (PRB) Step
2012 Ford F 150 2WD V8-6.2LSECTION Power Running Board (PRB) Step
Power Running Board (PRB) Step
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: If the Power Running Board (PRB) cannot be extracted, extend the running board by hand.
Extend the PRB (Power Running Board).
3. Remove the 2 front and 2 rear PRB (Power Running Board) bracket-to-step screws and the PRB (Power Running Board) step
- To install, tighten to 12 Nm (106 lb-in).
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.