Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER MOTORSERVICE AND REPAIRWIPER MOTOR - WINDSHIELD
2012 Ford Explorer FWD V6-3.5L
Wiper Motor - Windshield
2012 Ford Explorer FWD V6-3.5LSECTION Wiper Motor - Windshield
Wiper Motor - Windshield
Removal
1. Remove the wiper mounting arm and pivot shaft. REFER to Wiper Mounting Arm and Pivot Shaft .
2. Using a flat-blade screwdriver or a suitable tool at the location shown, separate the wiper motor linkage arm from the wiper pivot arm linkage.
3. Remove the 4 wiper motor bolts and the wiper motor.
- To install, tighten to 18 Nm (159 lb-in).
Installation
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.