Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER ARMSERVICE AND REPAIRWIPER PIVOT ARM - FRONT
2012 Ford Explorer FWD V6-3.5L
Wiper Pivot Arm - Front
2012 Ford Explorer FWD V6-3.5LSECTION Wiper Pivot Arm - Front
Wiper Pivot Arm - Front
Removal
1. Remove the wiper pivot arm nut cover.
2. Remove the wiper pivot arm nut.
3. Using a suitable 2 jaw puller, remove the wiper pivot arm.
Installation
1. Using a wire brush, clean the wiper pivot arm shaft.
2. Cycle and park the windshield wipers.
3. Install the wiper pivot arm.
4. Align the RH (Right Hand) and LH (Left Hand) windshield wiper blades to the alignment marks on the windshield glass.
5. Install the 2 wiper pivot arm nuts.
- Tighten to 30 Nm (22 lb-ft).
6. Install the wiper pivot arm nut cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.