Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER PUMPSERVICE AND REPAIRWASHER PUMP
2012 Ford Explorer FWD V6-3.5L
Washer Pump
2012 Ford Explorer FWD V6-3.5LSECTION Washer Pump
Washer Pump
Removal
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product MSDS (Material Safety Data Sheet), if available. Failure to follow these instructions may result in serious personal injury.
NOTE: When installing a new washer pump, be careful not to damage the rubber grommet.
NOTE: To prevent spilling washer fluid, drain the washer reservoir before washer pump removal.
1. Remove the RF (Right Front) fender splash shield. REFER to Fender Splash Shield .
2. NOTE: Front bumper removed for clarity.
Disconnect the washer pump electrical connector.
3. NOTE: Front bumper removed for clarity.
Disconnect the washer hoses.
4. NOTE: Front bumper removed for clarity.
Remove the washer pump.
Installation
1. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature pump failure.
NOTICE: When installing a new washer pump, be careful not to damage the rubber grommet.
To install, reverse the removal procedure.
- Fill the washer reservoir with windshield washer fluid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.