Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRSTEERING COLUMN MULTIFUNCTION SWITCH
2012 Ford Explorer FWD V6-3.5L
Steering Column Multifunction Switch
2012 Ford Explorer FWD V6-3.5LSECTION Steering Column Multifunction Switch
Steering Column Multifunction Switch
Exploded View
Removal
1. Remove the steering column shrouds. REFER to Steering Column Shroud .
2. Turn the steering wheel 90 degrees to the left.
3. If equipped, remove the brake pedal adjust switch. REFER to Pedal Adjust Switch .
4. Remove the screw(s) and the multifunction switch.
Installation
1. Position the multifunction switch and install the screw(s).
- Tighten to 1 Nm (9 lb-in).
2. If equipped, install the brake pedal adjust switch. REFER to Pedal Adjust Switch .
3. Install the steering column shrouds. REFER to Steering Column Shroud .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.