Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMDESCRIPTION AND OPERATIONSTARTING SYSTEM - WITHOUT INTELLIGENT ACCESS (IA)OVERVIEW
2012 Ford Explorer FWD V6-3.5L
Starting System - without Intelligent Access (IA): Overview
2012 Ford Explorer FWD V6-3.5LSECTION Overview
Starting System - without Intelligent Access (IA)
Overview
The starter system controls the cranking of the engine. The starter motor is enabled by the starter relay when the relay is activated by the PCM (Powertrain Control Module). The ignition switch provides voltage to the BCM (Body Control Module) and PCM (Powertrain Control Module) to initiate cranking of the engine.
Remote Start
The remote start feature allows the operator to remotely start the engine from up to 100 meters (328 feet) away and is activated using the IKT (Integrated Keyhead Transmitter). Once started, the engine runs for 10 minutes. The run time can be extended by the operator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.