Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSWHEEL SPEED SENSORSERVICE AND REPAIRWHEEL SPEED SENSOR - REAR
2012 Ford Explorer FWD V6-3.5L
Wheel Speed Sensor - Rear
2012 Ford Explorer FWD V6-3.5LSECTION Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Exploded View
Removal
1. Disconnect the wheel speed sensor electrical connector.
2. Detach the 2 pin-type retainers.
3. Detach the 2 grommets from the routing brackets.
4. Remove the rear wheel speed sensor bolt and the rear wheel speed sensor.
Installation
1. Position the rear wheel speed sensor and install the rear wheel speed sensor bolt.
- Tighten to 15 Nm (133 lb-in).
2. Attach the 2 grommets to the routing brackets.
3. Attach the 2 pin-type retainers.
4. Connect the wheel speed sensor electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.