Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMESEATSPOWER SEAT SWITCHSERVICE AND REPAIRSEATING - 2ND ROW
2012 Ford Explorer FWD V6-3.5L
Seating - 2nd Row
2012 Ford Explorer FWD V6-3.5LSECTION Seating - 2nd Row
Seat Control Switch
Exploded View
Removal
1. Pull the quarter trim panel away from the weather strip at the rear door opening.
2. Squeeze the tabs at the top and bottom of the seat control switch together and push the switch out through the front of the quarter trim panel.
3. Disconnect and remove the seat control switch.
Installation
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.