Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMCONSOLESERVICE AND REPAIRCONSOLE - FRONT, FLOOR
2012 Ford Explorer FWD V6-3.5L
Console - Front, Floor
2012 Ford Explorer FWD V6-3.5LSECTION Console - Front, Floor
Console - Front, Floor
Exploded View
Front Floor Console Finish Panels
Front Floor Console Trim Panels
Front Floor Console Fasteners
Removal
1. Apply the parking brake.
2. Place the selector lever to the full rearward position.
3. Position the front seats fully rearward and fully reclined.
4. Remove the LH (Left Hand) and the RH (Right Hand) front floor console side trim panels.
- Pull outward to release the retainers.
5. Disconnect the shifter cable from the selector lever.
6. Disconnect the shifter cable from the front floor console bracket.
7. Disconnect the front floor console bulkhead electrical connector, the USB (Universal Serial Bus) cable and if equipped, the 110V power outlet connector from the side of the console.
8. Detach the LH (Left Hand) and the RH (Right Hand) carpet push pins from the front floor console.
9. Remove the 8 console bolts.
- To install, tighten to 5.4 Nm (48 lb-in).
10. Remove the floor console.
Installation
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.