Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER AWD V6-3.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSTESTING AND INSPECTIONPINPOINT TESTSDIAGNOSTIC ROUTINE K
2012 Ford Explorer AWD V6-3.5L
Diagnostic Routine K
2012 Ford Explorer AWD V6-3.5LSECTION Diagnostic Routine K
Diagnostic Routine K
Diagnostic Overview
All Power Windows Are Inoperative - Base
Refer to Wiring Diagram Set 100 for schematic and connector information Electrical Diagrams.
Normal Operation and Fault Conditions
The accessory delay relay provides the voltage for all power window operation. REFER to Delayed Accessory Power .
Pinpoint Test
1. CHECK FOR VOLTAGE TO THE LH (Left Hand) FRONT WINDOW CONTROL SWITCH
1. Disconnect: LH (Left Hand) Front Window Control Switch C535B.
2. Ignition ON.
3. Measure:
Is the voltage greater than 11 volts?
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.