Fog/Driving Lamp: Service and Repair

2012 Ford Explorer AWD V6-3.5LSECTION Service and Repair



Fog Lamp

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Exploded View










Removal

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. Remove the front fender splash shield. REFER to Fender Splash Shield .

2. Remove the fog lamp assembly.

1. Disconnect the fog lamp electrical connector at the fog lamp assembly.

2. Remove the 4 fog lamp assembly screws and the fog lamp assembly.

Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. Install the fog lamp assembly.

1. Install the fog lamp assembly and the 4 screws.

2. Connect the fog lamp assembly electrical connector at the fog lamp assembly.

2. Install the front fender splash shield. REFER to Fender Splash Shield .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.