Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER AWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSBACKUP LAMPSERVICE AND REPAIR
2012 Ford Explorer AWD V6-3.5L
Backup Lamp: Service and Repair
2012 Ford Explorer AWD V6-3.5LSECTION Service and Repair
Rear Lamp Assembly
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Exploded View
Removal
1. Remove the 2 rear lamp assembly bolt covers.
2. Remove the 2 rear lamp assembly bolts.
3. Remove the rear lamp assembly and disconnect the electrical connectors.
Installation
1. Connect the electrical connectors and install the rear lamp assembly.
2. Install the 2 rear lamp assembly bolts.
- Tighten to 3 Nm (27 lb-in).
3. Install the 2 rear lamp assembly bolt covers.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.