Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPLORER AWD V6-3.5LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTSERVICE AND REPAIR
2012 Ford Explorer AWD V6-3.5L
Accessories and Optional Equipment: Service and Repair
2012 Ford Explorer AWD V6-3.5LSECTION Service and Repair
Accessory Protocol Interface Module (APIM)
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Exploded View
Removal
1. Remove the FCDIM (Front Control/Display Interface Module). REFER to Front Controls Interface Module (FCIM) .
2. Remove the 4 screws and remove the APIM (Accessory Protocol Interface Module) from the APIM (Accessory Protocol Interface Module) bracket.
- To install, tighten to 0.6 Nm (5 lb-in).
Installation
1. To install, reverse the removal procedure.
2. Program the APIM (Accessory Protocol Interface Module). REFER to Accessory Protocol Interface Module (APIM) Module Replacement Programming.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.