Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPEDITION 2WD V8-5.4LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRBATTERY TRAY
2012 Ford Expedition 2WD V8-5.4L
Battery Tray
2012 Ford Expedition 2WD V8-5.4LSECTION Battery Tray
Battery Tray
1. Remove the battery. For additional information, refer to Battery .
2. Disconnect the wire harness retainers from the battery tray and position the wire harness aside.
3. Remove the 3 bolts from the battery tray and carefully position the battery tray aside to gain access to the washer reservoir electrical connector.
- To install, tighten to 17 Nm (150 lb-in).
4. Disconnect the wire connector and washer hose from the washer bottle and remove the battery tray assembly.
5. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.