Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EXPEDITION 2WD V8-5.4LREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERFRONT FENDER LINERSERVICE AND REPAIRFENDER SPLASH SHIELD
2012 Ford Expedition 2WD V8-5.4L
Fender Splash Shield
2012 Ford Expedition 2WD V8-5.4LSECTION Fender Splash Shield
Fender Splash Shield
Vehicles with power running boards
1. Lower the running board.
2. WARNING: Turn off (disable) the power running boards (if equipped) before jacking, lifting or placing any object under the vehicle.
Never place your hand between the power running board and the vehicle. Extended power running boards will retract when doors are closed.
Failure to follow these instructions may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
All vehicles
3. Remove the lower pin-type retainer from the fender.
4. Remove the 8 fender splash shield screws.
5. Remove the 2 inner pin-type retainers from the fender splash shield.
6. Remove the fender splash shield.
7. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.