Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012ESCAPE 4WD L4-2.5LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINMANUAL TRANSMISSION/TRANSAXLESERVICE AND REPAIRPROCEDURES
2012 Ford Escape 4WD L4-2.5L
Procedures
2012 Ford Escape 4WD L4-2.5LSECTION Procedures
Transaxle Draining and Filling
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the drain plug and drain the fluid.
3. NOTE: Use a new gasket and apply sealant on the drain plug.
Install the drain plug.
- Tighten to 35 Nm (26 lb-ft).
4. Remove the fill level inspection plug.
5. Fill the transmission with gear oil through the fill level inspection plug hole, until level with the fill level inspection plug hole.
6. NOTE: Use a new gasket and apply sealant on the fill level inspection plug.
Install the fill level inspection plug.
- Tighten to 35 Nm (26 lb-ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.