Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012ESCAPE 4WD L4-2.5LREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONAUXILIARY POWER OUTLETSERVICE AND REPAIR
2012 Ford Escape 4WD L4-2.5L
Auxiliary Power Outlet: Service and Repair
2012 Ford Escape 4WD L4-2.5LSECTION Service and Repair
Power Point
Removal
NOTE: Power point cover may differ depending on location.
1. Open the power point cover.
2. Install the Power Point Socket Remover in one of the power point socket slots.
3. Position the Power Point Socket Remover so that it engages in the adjacent slot.
4. Using the Power Point Socket Remover, pull the power point socket out of the retainer.
5. Disconnect the electrical connector.
Installation
1. Connect the electrical connector.
2. Slide the power point socket into the retainer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.