Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012ESCAPE 2WD L4-2.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSFOG/DRIVING LAMPSERVICE AND REPAIR
2012 Ford Escape 2WD L4-2.5L
Fog/Driving Lamp: Service and Repair
2012 Ford Escape 2WD L4-2.5LSECTION Service and Repair
Fog Lamp
NOTE: Escape shown, Mariner similar.
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
Escape
2. Remove the 4 fender splash shield bolts.
- To install, tighten to 5 Nm (44 lb-in).
3. Remove the 4 fender splash shield pin-type retainers.
- Position the fender splash shield aside.
All vehicles
4. Disconnect the fog lamp electrical connector.
5. Release the 3 retainers and remove the fog lamp.
6. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.