Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012ESCAPE 2WD L4-2.5LREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERFRONT FENDER LINERSERVICE AND REPAIRFENDER SPLASH SHIELD
2012 Ford Escape 2WD L4-2.5L
Fender Splash Shield
2012 Ford Escape 2WD L4-2.5LSECTION Fender Splash Shield
Fender Splash Shield
Removal and Installation
1. Remove the 3 fender splash shield bolts.
- To install, tighten to 5 Nm (44 lb-in).
2. Remove the 7 fender splash shield pin-type retainers.
3. Remove the 6 fender splash shield screws.
- To install, tighten to 5 Nm (44 lb-in).
4. Remove the fender splash shield.
5. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.