Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012ESCAPE 2WD L4-2.5L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION COILSERVICE AND REPAIRIGNITION COIL-ON-PLUG
2012 Ford Escape 2WD L4-2.5L Hybrid
Ignition Coil-On-Plug
2012 Ford Escape 2WD L4-2.5L HybridSECTION Ignition Coil-On-Plug
Ignition Coil-On-Plug
Removal and Installation
1. Disconnect the 4 ignition coil electrical connectors.
2. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
Remove the 4 bolts and the ignition coils.
- To install, tighten to 8 Nm (71 lb-in).
3. Inspect the coil seals for rips, nicks or tears. Remove and discard any damaged coil seals.
- To install, slide the new coil seal onto the coil until fully seated at the top of the coil.
4. To install, reverse the removal procedure.
- Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.