Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE FWD V6-3.7LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE ROTOR/DISCSERVICE AND REPAIRREAR DISC BRAKEBRAKE DISC SHIELD
2012 Ford Edge FWD V6-3.7L
Brake Disc Shield
2012 Ford Edge FWD V6-3.7LSECTION Brake Disc Shield
Brake Disc Shield
Removal and Installation
1. Remove the brake caliper anchor plate. For additional information, refer to Brake Caliper Anchor Plate Brake Caliper Anchor Plate.
2. Remove and discard the brake disc screw and remove the brake disc.
- To install, tighten to 20 Nm (177 lb-in).
3. Remove the 3 bolts and the brake disc shield.
- To install, tighten to 15 Nm (133 lb-in).
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.