Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMEDESCRIPTION AND OPERATIONSUBFRAME AND MOUNTING SYSTEMS
2012 Ford Edge FWD V6-3.5L
Subframe and Mounting Systems
2012 Ford Edge FWD V6-3.5LSECTION Subframe and Mounting Systems
Subframe and Mounting Systems
Front Subframe
The front subframe is bolted to the body and is used to:
- aid in structural support.
- provide mounting surfaces for the front suspension control arms.
- provide the mounting surface for the steering gear.
- provide the mounting surface for the sway bar.
Rear Subframe
The rear subframe is bolted to the body and is used to:
- aid in structural support.
- provide mounting surfaces for the rear suspension control arms.
- provide a mounting point for the rear differential, if equipped.
- provide a mounting surface for the sway bar.
Underbody misalignment can affect front and rear wheel alignment, the operation of the suspension parts and drivetrain operation. Window glass cracks, door and window opening concerns and air or water leaks at the doors are often caused by incorrectly tightened bolts and body misalignment. For body misalignment and checking, refer to Body Repairs. Before any welding is carried out on the vehicle, refer to Body Repairs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.