Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE AWD V6-3.7LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER RESERVOIRSERVICE AND REPAIR
2012 Ford Edge AWD V6-3.7L
Windshield Washer Reservoir: Service and Repair
2012 Ford Edge AWD V6-3.7LSECTION Service and Repair
Washer Reservoir
Removal and Installation
1. Remove the RH front fender splash shield.
2. Disconnect the washer pump electrical connector.
3. Drain the washer reservoir.
4. Disconnect the washer pump hoses.
5. Remove the bolt from the washer reservoir filler neck.
- To install, tighten to 9 Nm (80 lb-in).
6. Remove the washer reservoir nuts and the washer reservoir.
- To install, tighten to 9 Nm (80 lb-in).
7. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow these instructions may result in premature pump failure.
To install, reverse the removal procedure.
- Fill the washer reservoir with windshield washer fluid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.