Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE AWD V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONFUEL PUMPSERVICE AND REPAIRPROCEDURES
2012 Ford Edge AWD V6-3.7L
Procedures
2012 Ford Edge AWD V6-3.7LSECTION Procedures
Fuel Injection Pump Tappet Inspection
1. Inspect the fuel injection pump tappet for flat spots or scoring, especially in the indicated areas. Visual check.
2. If any damage is found, inspect the fuel injection pump and the fuel injection pump tappet drive lobe. Install new components as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.