Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE AWD V6-3.7LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER HEAD ASSEMBLYSPECIFICATIONS
2012 Ford Edge AWD V6-3.7L
Cylinder Head Assembly: Specifications
2012 Ford Edge AWD V6-3.7LSECTION Specifications
Cylinder Head
Install a new gasket, the RH cylinder head and 8 new bolts. Tighten in the sequence shown in 5 stages:
Stage 1: Tighten to 20 Nm (177 lb-in).
Stage 2: Tighten to 35 Nm (26 lb-ft).
Stage 3: Tighten 90 degrees.
Stage 4: Tighten 90 degrees.
Stage 5: Tighten 45 degrees.
Install the bolt.
Tighten to 10 Nm (89 lb-in).
Install a new gasket, the LH cylinder head and 8 new bolts. Tighten in the sequence shown in 5 stages:
Stage 1: Tighten to 20 Nm (177 lb-in).
Stage 2: Tighten to 35 Nm (26 lb-ft).
Stage 3: Tighten 90 degrees.
Stage 4: Tighten 90 degrees.
Stage 5: Tighten 45 degrees.
Install the bolt.
Tighten to 10 Nm (89 lb-in).
Bolt re-usability
NOTE: The cylinder head bolts must be discarded and new bolts must be installed. They are tighten-to-yield designed and cannot be reused.
Surface Variation -- Head-to-block, Head-to-manifolds And Surface Variation -- Warpage
Camshaft Bearing Cap
RH
Install the 6 camshaft caps, mega cap, valve train oil tube and the 15 bolts in the sequence shown.
Tighten to 8 Nm (71 lb-in) then additional 45 degrees.
Tighten the 4 camshaft caps bolts in the sequence shown.
Tighten bolts 8, 9, 10 and 11 to 8 Nm (71 lb-in) then additional 45 degrees.
LH
Install the 6 camshaft caps, mega cap, valve train oil tube and the 15 bolts in the sequence shown.
Tighten to 8 Nm (71 lb-in) then additional 45 degrees.
Tighten the 4 camshaft caps bolts in the sequence shown.
Tighten bolts 8, 9, 10 and 11 to 8 Nm (71 lb-in) then additional 45 degrees.
Intake Manifold Specifications
Exhaust Manifold Specifications
Camshaft Gear/Sprocket Specifications
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.