Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE AWD V6-3.5LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINDIFFERENTIAL ASSEMBLYDESCRIPTION AND OPERATIONDRIVELINE SYSTEM
2012 Ford Edge AWD V6-3.5L
Driveline System
2012 Ford Edge AWD V6-3.5LSECTION Driveline System
Driveline System
The driveline system consists of the following components:
- Center support bearing
- Driveshaft assembly
- Front halfshafts
- Rear halfshafts
- Active torque coupling/rear axle
On Front Wheel Drive (FWD) vehicles, the transaxle transmits power from the engine to the halfshafts.
On All-Wheel Drive (AWD) vehicles, power is transmitted from the engine through the transaxle to the Power Transfer Unit (PTU). The PTU (Power Transfer Unit) transfers engine power from the transaxle to the front halfshafts, and through the driveshaft to the active torque coupling/rear axle and halfshafts. For information on the PTU (Power Transfer Unit), refer to Transfer Case.
The engine angle is built into the engine mounts. If the engine angle is out of specification, the engine mounts must be inspected for damage. Refer to Engine.
Vehicle Certification (VC) Label Example
The Vehicle Certification (VC) label is located in the driver door jamb. The axle code is on the VC (Vehicle Certification) label.
The axle ratio's used are 3.16, 3.21, 3.36, and 3.39. The ring gear has a diameter of 174 mm (6.85 in).
The wheel speed sensor rings for FWD (Front Wheel Drive) vehicles are located on the front halfshafts and are mounted to the rear inner spindles.
The wheel speed sensor rings are located on the front and rear halfshafts for AWD (All-Wheel Drive) vehicles.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.