Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE AWD V6-3.5LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYCONNECTING RODSERVICE AND REPAIRCONNECTING ROD CLEANING
2012 Ford Edge AWD V6-3.5L
Connecting Rod Cleaning
2012 Ford Edge AWD V6-3.5LSECTION Connecting Rod Cleaning
Connecting Rod Cleaning
NOTICE: Do not use a caustic cleaning solution or damage to connecting rods can occur.
1. NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the original connecting rod in the original position. Do not reverse the cap. Parts are not interchangeable.
Mark and separate the parts and clean with solvent. Clean the oil passages.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.