Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012EDGE AWD V6-3.5LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE ROTOR/DISCSERVICE AND REPAIRFRONT DISC BRAKEBRAKE DISC
2012 Ford Edge AWD V6-3.5L
Brake Disc
2012 Ford Edge AWD V6-3.5LSECTION Brake Disc
Brake Disc
Removal
1. Remove the wheel and tire.
2. NOTICE: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
- Support the caliper and anchor plate assembly using mechanic's wire.
3. Remove the brake disc.
Installation
1. NOTICE: Do not apply anti-seize to wheel studs or incorrect tightening of the wheel nuts may occur.
Using the specified brake parts cleaner, clean and dry the brake disc-to-wheel hub mounting surface, then apply a thin coat of the specified anti-seize where indicated.
2. NOTE: Make sure the brake disc is clean and free of any foreign material.
Install the brake disc.
3. Position the brake caliper and anchor plate assembly and the brake caliper anchor plate bolts.
- Tighten to 133 Nm (98 lb-ft).
4. Install the wheel and tire.
- Apply brakes several times to verify correct brake operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.