Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2012E 450 V8-5.4LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER PUMPSERVICE AND REPAIR
2012 Ford E 450 V8-5.4L
Windshield Washer Pump: Service and Repair
2012 Ford E 450 V8-5.4LSECTION Service and Repair
Washer Pump and Reservoir
Removal
1. Remove the battery tray.
2. Remove the windshield wiper reservoir nut and bolt.
- To install, tighten to 4 Nm (35 lb-in).
3. Disconnect the filler hose from the reservoir.
4. Disconnect the washer pump electrical connector and wiring harness locator.
5. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE: If necessary, drain the windshield washer reservoir after removal.
Disconnect the windshield washer hose and remove the washer pump and reservoir.
6. NOTICE: Do not operate the windshield washer pump before filling the windshield washer reservoir. Failure to do so could result in premature pump failure.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.